Add a system
1
Open Systems
Open My Home, then Systems, and select Add a system.
2
Choose which one
Pick a tile: furnace, boiler, air conditioning, water heater, air exchanger, sump pump, roof, eavestroughs, garage door, washer, dryer, dishwasher, stove, septic system or well pump. For anything else, choose Something else.
3
Add its age
Under Age, enter the Year it went in, like 2014. If you don’t know it, choose Or roughly how old it is: under 5 years, and so on up to over 15.
4
Add service and details
Add Last serviced and a Service rhythm, like once a year. Under Details, add the Brand, Model, Warranty ends and Rented from, if it is a rental.
5
Save
Select Add.
What each system shows
Ages are measured against the trade’s typical service life. They are not a prediction about your system.
Scan its label
Owners and co-owners can select Scan its label on a system and take one photo of its rating plate. Zu reads the label and shows what it found, like the brand, model and the year its serial number says it was made. Tick what is right and select Save. Nothing is stored until you save, and reading a label uses one AI use.Keep the service date current
When you log work on Activity, pick the system under Which system was it? Systems then shows that date as its last service.Common questions
How do I find out how old my furnace is?
Look for the year on the rating plate inside the furnace door, or use Scan its label. If you can’t find it, choose a rough age.Where does the age show?
On the system’s card in Systems, and on the system ages line on Today.Is the replacement cost an estimate?
No. It is a figure you enter yourself. Zulma does not estimate it.What to read next
Work done
Log a service against a system
Receipts and warranties
Keep its warranty with the home